Residential Inspections     [all categories]
  Structural, Foundation, Crawlspace, Insulation & Ventilation, Basement
  Garage door opening header.

Post New Topic  Post A Reply
profile | register | preferences | faq | search

Click Here To Return To InspectionNews.com
UBBFriend: Email This Page to Someone!
next newest topic | next oldest topic
Author Topic:   Garage door opening header. - 717 visits (1 today, 1 this week)
Ryan McNabb
Member

Posts: 21
From:Baton Rouge, LA
Registered: Jul 2003

posted May 25, 2004 07:26 PM     Click Here to See the Profile for Ryan McNabb   Click Here to Email Ryan McNabb     Edit/Delete Message
On a 3 year old house today was a large 2 car garage. Don't know the exact width of the garage door opening, but the header has a very slight sag in it. I only noticed it because I made an effort to look for it, but the sag was only about 1/2 inch difference between the ends and the center of the sag. How much of a concern is this. It was barely noticable, but I feel that I should at least mention it.

Rick Hurst
Member

Posts: 827
From:Rowlett, TX
Registered: Oct 2003

posted May 25, 2004 07:50 PM     Click Here to See the Profile for Rick Hurst   Click Here to Email Rick Hurst     Edit/Delete Message
Ryan,

If you noticed the sagging so could someone else like your client.

The header should not be sagging. You should write it up.

If it looks wrong, it probably is.

Rick

Susan Cieslewicz
Member

Posts: 845
From:Lake Villa, Il
Registered: Sep 2002

posted May 25, 2004 08:03 PM     Click Here to See the Profile for Susan Cieslewicz   Click Here to Email Susan Cieslewicz     Edit/Delete Message
Ryan,

Good catch. Probably too small or not doubled or tripled up. How did the ends look? Were they bearing on adequate cripples? Could be a future problem and you did the write thing by noting it.

Sue

Ryan McNabb
Member

Posts: 21
From:Baton Rouge, LA
Registered: Jul 2003

posted May 25, 2004 08:12 PM     Click Here to See the Profile for Ryan McNabb   Click Here to Email Ryan McNabb     Edit/Delete Message
Thanks for the quick advice. I could not see how the header was framed because of the exterior brick veneer and the interior sheetrock. Basically what I could see sagging was the wooden lintle holding the brick veneer above. There was little if any cracking of the brick.

James Napier
Member

Posts: 69
From:Nashville, TN
Registered: Feb 2004

posted May 26, 2004 04:22 AM     Click Here to See the Profile for James Napier   Click Here to Email James Napier     Edit/Delete Message
Ryan,
How far was the span? If there was a wooden lintel holding the brick up, I would think you would get some sag in it.

Linda Swearingen
New Member

Posts: 11
From:Mayfield, Ky
Registered: Jan 2001

posted June 13, 2004 02:01 PM     Click Here to See the Profile for Linda Swearingen   Click Here to Email Linda Swearingen     Edit/Delete Message
I don't know about your area, but here in Western Kentucky the lintel is required to be masonry or metal; wood isn't allowed to support a brick wall, not even when it's just veneer.

All times are PT (US Pacific Time)

next newest topic | next oldest topic


Administrative Options: Close Topic | Archive/Move | Delete Topic
Post New Topic  Post A Reply Track This Topic via Email
Hop to:

Contact Us | InspectionNews.com

Powered by Infopop 2000
Ultimate Bulletin Board 5.45c